2. Run:
pim [ vpn-instance vpn-instance-name ]
The PIM view is displayed.
3. Run:
timer hello interval
The interval for sending Hello messages is set.
4. Run:
hello-option holdtime interval
The timeout period of holding the reachable state of a neighbor is set.
If no Hello message is received after the interval expires, the neighbor is considered
unreachable.
l Configuration on an Interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
3. Run:
pim timer hello interval
The interval for sending Hello messages is set.
4. Run:
pim triggered-hello-delay interval
The maximum delay for triggering Hello messages is set.
This can prevent the conflict of Hello messages sent by multiple PIM switchs at the
same time.
5. Run:
pim hello-option holdtime interval
The timeout period of holding the reachable state of a neighbor is set.
If no Hello message is received after the interval expires, the neighbor is considered
unreachable.
6. Run:
pim require-genid
The Generation ID option is contained in a received Hello message. The Hello message
without the Generation ID option is rejected.
By default, the switch handles the Hello message without the Generation option.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 6 PIM-SM (IPv4) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
168
To Next Page
Loading...
