Huawei quidway s7700 - Page 296

Figure 7-3 Networking diagram for configuring anycast RP
Receiver
user2
Loopback10
Loopback0
Loopback0
Loopback10
GE2/0/0
GE3/0/0
SwitchC
SwitchD
SwitchE
PIM-SM
MSDP peers
Source
Loopback1
Loopback1
GE2/0/0
GE3/0/0
GE2/0/0
GE1/0/0
SwitchA
SwitchB
GE1/0/0
GE2/0/0
Receiver
user1
Source
S2
GE1/0/0
GE2/0/0
GE1/0/0
GE1/0/0
S1
Switch Interface VLANIF interface IP address
SwitchA GE 1/0/0 VLANIF 105 10.110.5.1/24
GE 2/0/0 VLANIF 101 10.110.1.2/24
SwitchB GE 1/0/0 VLANIF 106 10.110.6.1/24
GE 2/0/0 VLANIF 102 10.110.2.2/24
SwitchC GE 1/0/0 VLANIF 100 192.168.1.1/24
GE 2/0/0 VLANIF 101 10.110.1.1/24
GE 3/0/0 VLANIF 104 10.110.4.1/24
Loopback0 1.1.1.1/32
Loopback1 3.3.3.3/32
Loopback10 10.1.1.1/32
SwitchD GE 1/0/0 VLANIF 300 192.168.3.1/24
GE 2/0/0 VLANIF 102 10.110.2.1/24
GE 3/0/0 VLANIF 103 10.110.3.1/24
Loopback0 2.2.2.2/32
Loopback1 4.4.4.4/32
Loopback10 10.1.1.1/32
SwitchE GE 1/0/0 VLANIF 300 192.168.3.2/24
GE 2/0/0 VLANIF 100 192.168.1.2/24
Configuration Roadmap
Configure anycast RPs. Then the receiver sends a Join message to the nearest RP and the
multicast source sends a Register message to the nearest RP.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 7 MSDP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
277