query messages, and maximum response time are used, the Keepalive period of the
other MLD queriers is 255 seconds.
7. Run:
lastlistener-queryinterval interval
The interval for sending last listener query messages is set.
The shorter the interval, the more sensitive the querier. By default, the interval is 1
second.
l Configuration on an Interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
mld timer query interval
The interval for sending MLD general query messages is set.
4. Run:
mld max-response-time interval
The maximum response time of the MLD Query message is set.
5. Run:
mld timer other-querier-present interval
The Keepalive period of the other MLD queriers is set.
6. Run:
mld robust-count robust-value
The MLD robustness variable is set.
7. Run:
mld lastlistener-queryinterval interval
The interval for sending MLD last listener query messages is set.
8. Run:
mld prompt-leave [ group-policy { basic-acl6-number | acl6-name acl6-
name } ]
MLD fast leave is configured.
When an interface receives a Leave message for a certain group, the interface
immediately deletes the downstream interface of the entry to which the group
corresponds, without sending the last listener query message.
By default, when a switch receives a Leave message for a group, the switch sends last
listener query messages.
This command is only valid for MLDv1.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 10 MLD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
367
To Next Page
Loading...
