Huawei quidway s7700 - Page 396

Figure 10-1 Networking diagram for configuring basic MLD functions
SwitchA
SwitchB
SwitchC
GE2/0/0
GE1/0/0
3000::12/64
PIM network
GE2/0/0
GE2/0/0
GE1/0/0
3001::10/64
GE1/0/0
3001::12/64
Ethernet
HostA
Receiver
HostB
N1
Leaf network
HostC
Receiver
HostD
N2
Ethernet
Switch Physical interface VLANIF interface IP address
SwitchA GE1/0/0 VLANIF100 3000::12/64
GE2/0/0 VLANIF101 2002::1/64
SwitchB GE1/0/0 VLANIF200 3001::10/64
GE2/0/0 VLANIF201 2002::1/64
SwitchC GE1/0/0 VLANIF300 3001::12/64
GE2/0/0 VLANIF301 2002::1/64
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable IPv6 Multicast on the S7700s.
2. Enable IPv6 PIM-SM on all the interfaces on S7700.
3. Enable MLD on the interface at the host side.
Data Preparation
To complete the configuration, you need the following data:
l MLD version running between the S7700s and the user hosts
Procedure
Step 1 Create VLANs and VLAN interfaces on the S7700s and assign IP addresses to the VLAN
interfaces. The configuration procedure is not provided here.
Step 2 Enable multicast on the S7700s and enable MLD and IPv6 PIM-DM on the interfaces connected
to user hosts.
# Enable multicast on SwitchA, enable MLD and IPv6 PIM-DM on VLANIF 100, and set the
MLD version to 2.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 10 MLD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
377