Huawei quidway s7700 - Page 401

[SwitchA] interface vlanif 100
[SwitchA-Vlanif100] mld limit 30
[SwitchA-Vlanif100] quit
# Configurations of Switch B and Switch C are similar to those of Switch A, and are not
mentioned here.
Step 4 Verify the configuration.
# Run the display mld interface command to view the configuration and running status of MLD
on the switch interface. MLD information on VLANIF 100 of Switch B is as follows:
[SwitchB] display mld interface vlanif 100
Interface information
Vlanif100(FE80::200:5EFF:FE66:5100):
MLD is enabled
Current MLD version is 1
MLD state: up
MLD group policy: none
MLD limit: 30
Value of query interval for MLD (negotiated): -
Value of query interval for MLD (configured): 125 s
Value of other querier timeout for MLD: 0 s
Value of maximum query response time for MLD: 10 s
Querier for MLD: FE80::200:5EFF:FE66:5100 (this router)
Querier for MLD: FE80::200:5EFF:FE66:5100 (this router)
From the display, you can see that the maximum number of MLD group members that the
VLANIF 100 of Switch B can creat is 30.
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 100 101
#
ipv6
#
mld global limit 50
#
multicast ipv6 routing-enable
#
interface Vlanif100
ipv6 enable
ipv6 address 3000::12/64
pim ipv6 sm
mld enable
mld limit 30
#
interface Vlanif101
ipv6 enable
ipv6 address 2001::1/64
pim ipv6 sm
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet2/0/0
pport hybrid pvid vlan 101
port hybrid untagged vlan 101
#
mld
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 10 MLD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
382