EasyManua.ls Logo

Huawei quidway s7700 - Page 517

Huawei quidway s7700
551 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
<SwitchB> display pim ipv6 bsr-info
VPN-Instance: public net
Elected AdminScoped BSR Count: 0
Elected BSR Address: 2004::2
Priority: 0
Hash mask length: 126
State: Accept Preferred
Uptime: 00:04:22
Expires: 00:01:46
C-RP Count: 1
<SwitchD> display pim ipv6 bsr-info
VPN-Instance: public net
Elected AdminScoped BSR Count: 0
Elected BSR Address: 2004::2
Priority: 0
Hash mask length: 126
State: Elected
Uptime: 00:01:10
Next BSR message scheduled at: 00:00:48
C-RP Count: 1
Candidate AdminScoped BSR Count: 0
Candidate BSR Address: 2004::2
Priority: 0
Hash mask length: 126
State: Elected
Wait to be BSR: 0
# Run the display pim ipv6 rp-info command to view the RP information on each S7700. Take
the RP information on SwitchB as an example.
<SwitchB> display pim ipv6 rp-info
VPN-Instance: public net
PIM-SM BSR RP information:
Group/MaskLen: FF3E::1/64
RP: 2004::2
Priority: 192
Uptime: 00:05:19
Expires: 00:02:11
Step 4 Configure the BSR boundary on the interface connecting SwitchA to the Internet.
[SwitchA] interface Vlanif 103
[SwitchA-Vlanif103] pim ipv6 bsr-boundary
[SwitchA-Vlanif103] quit
Step 5 Configure the SSM group address range on all S7700s on the network.
# Configure the PIM-IPv6 SSM group address range on SwitchA to FF3E::1/64.
[SwitchA] acl ipv6 2000
[SwitchA-acl6-basic-2000] rule permit source FF3E::1 64
[SwitchA-acl6-basic-2000] quit
[SwitchA] pim-ipv6
[SwitchA-pim6] ssm-policy 2000
[SwitchA-pim6] quit
The configurations of SwitchB, SwitchC, and SwitchD are similar to the configuration of
SwitchA, and are not provided here.
Step 6 Enable PIM silent and MLD on the interfaces connected to hosts.
# On SwitchB, enable PIM silent and MLD on the interface connected to hosts.
[SwitchB] interface Vlanif 201
[SwitchB-Vlanif201] pim ipv6 silent
[SwitchB-Vlanif201] mld enable
[SwitchB-Vlanif201] quit
The configuration on SwitchC is similar to the configuration on SwitchB, and is not provided
here.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 13 PIM-SM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
498

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals