Huawei quidway s7700 - Page 525

[SwitchC-pim6] graceful-restart
[SwitchC-pim6] graceful-restart period 300
[SwitchC-pim6] quit
Step 6 Verify the configuration.
# Configure the multicast source (2001:1::1) to send data to the multicast group (FF2E::1) and
configure HostA to send an MLD Report message to the multicast group. Ensure that Receiver
can receive the data from the multicast source. Before SwitchC performs an active/standby
switchover, run the display pim ipv6 routing-table command on SwitchB and SwitchC to view
the multicast routing tables. The command output is as follows:
<SwitchB> display pim ipv6 routing-table
VPN-Instance: public net
Total 1 (*, G) entry; 1 (S, G) entry
(*, FF2E::1)
RP: 2002:1::1
Protocol: pim-sm, Flag: WC
UpTime: 00:00:53
Upstream interface: Vlanif30
Upstream neighbor: FE80::E0:F2C:3C02:1
RPF prime neighbor: FE80::E0:F2C:3C02:1
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlanif40
Protocol: pim-sm, UpTime: 00:00:53, Expires: 00:02:37
(2001:1::1, FF2E::1)
RP: 2002:1::1
Protocol: pim-sm, Flag: SPT ACT
UpTime: 00:21:24
Upstream interface: Vlanif30
Upstream neighbor: FE80::E0:F2C:3C02:1
RPF prime neighbor: FE80::E0:F2C:3C02:1
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlanif40
Protocol: pim-sm, UpTime: 00:00:53, Expires: 00:03:07
<SwitchC> display pim ipv6 routing-table
VPN-Instance: public net
Total 1 (*, G) entry; 1 (S, G) entry
(*, FF2E::1)
RP: 2002:1::1
Protocol: pim-sm, Flag: WC
UpTime: 00:01:16
Upstream interface: Vlanif50
Upstream neighbor: FE80::5463:0:9245:2
RPF prime neighbor: FE80::5463:0:9245:2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlanif60
Protocol: mld, UpTime: 00:01:16, Expires: -
(2001:1::1, FF2E::1)
RP: 2002:1::1
Protocol: pim-sm, Flag: SPT ACT
UpTime: 00:01:16
Upstream interface: Vlanif50
Upstream neighbor: FE80::5463:0:9245:2
RPF prime neighbor: FE80::5463:0:9245:2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlanif60
Protocol: pim-sm, UpTime: 00:01:16, Expires: -
# Run the following command on SwitchC to perform an active/standby switchover.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 13 PIM-SM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
506