Icom ID-31A

9
PRIORITY WATCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
9-23
Checks the VFO frequency (priority channel) every 5
seconds, while receiving a repeater in the DR mode.
Push [V/MHz] q
to select the VFO mode.
Rotate [DIAL] to set the receive frequency. w
Hold down [DR] e
for 1 second to select the DR
mode.
Push D-pad( r ) to select the “FROM”
(Access repeater) item.
D-pad
(�)
(Ent)
Rotate [DIAL] to select the desired repeater. t
Push y
.
Push D-pad( u ) to select “PRIO Watch,” and then
push D-pad(Ent).
• ON : When a signal is received on the prior-
ity channel, the VFO mode is automati-
cally selected.
• Bell : When a signal is received on the pri-
ority channel, a beep sounds and the
“PRIO” icon blinks on the DR mode
screen.
Push D-pad( i ) to select “ON” or “Bell,” and then
push D-pad(Ent).
• The “PRIO” icon is displayed and the priority scan
starts.
• To cancel the scan, push [CLR]
.
■ DR MODE AND VFO FREQUENCY
Push .
The selected repeater.
Hold down [DR]
for 1 sec-
ond.
[DIAL]
Example: Checks “432.380 MHz” every 5 seconds,
while receiving on the repeater in the DR
mode.
Appears Appears
Checks the VFO fre-
quency every 5 sec-
onds.
(Continued on page 9-24.)
Previous view