innomar SBP smart - Page 10

10 User’s Manual INNOMAR Parametric Sub-Bottom Profilers / SESWIN
10 Innomar Technologie GmbH (2023-01)
12.2 System setup and mobilisation .................................................................................... 141
12.3 Data acquisition .......................................................................................................... 143
12.4 Data Acquisition: Example Settings ............................................................................. 145
12.5 Data Quality Check (Innomar ISE Software) ............................................................... 146
12.6 Post Processing (Innomar ISE Software) .................................................................... 149
12.7 SEGY Data Export (Innomar SES-Convert Software) ................................................. 152
13 FAQ (Frequently Asked Questions) .................................................................. 153
13.1 System Performance ................................................................................................... 153
13.1.1 I do not get the seabed echo. ........................................................................................... 153
13.1.2 I do not get a seabed echo in the HF channel. ................................................................. 153
13.1.3 There is no data file recorded. .......................................................................................... 153
13.1.4 Transmitters are not switched on during data recording. ................................................. 153
13.1.5 How can I reduce acoustic interference with MBES? ....................................................... 154
13.1.6 What is the difference between the Innomar data formats? ............................................. 154
13.1.7 How do I get “SES” like echo plots from “RAW” and “SES3” data files? .......................... 155
13.1.8 Are there shortcuts to operate SESWIN with the keyboard?............................................ 157
13.1.9 How can I get a mouse pointer that is better to recognize? ............................................. 158
13.2 HF (100 kHz) Data Channel ........................................................................................ 159
13.2.1 How can I switch off the HF channel? .............................................................................. 159
13.2.2 How can I switch off HF data recording? .......................................................................... 159
13.2.3 How can I reduce the HF transmit power? ....................................................................... 159
13.3 Trigger / Synchronization ............................................................................................ 160
13.3.1 How can I reduce the ping rate? ....................................................................................... 160
13.3.2 How can I get a fixed ping rate? ....................................................................................... 160
13.3.3 How can I synchronize a sparker that runs at a lower ping rate? ..................................... 160
13.4 Motion Sensor / Motion (Heave/Roll/Pitch) Compensation .......................................... 161
13.4.1 Do I need a motion sensor? .............................................................................................. 161
13.4.2 Is a motion sensor included in the Innomar SBP? ............................................................ 161
13.4.3 What does “beam steering” or “beam stabilization” mean? .............................................. 161
13.5 Shipping / Transport / Storage .................................................................................... 162
13.5.1 Shall I remove / declare lithium batteries? ........................................................................ 162
13.5.2 How do I pack the equipment for transport? ..................................................................... 163
13.5.3 How shall I put the SBP in store? ..................................................................................... 163
13.5.4 Do I need an RMA number for sending the equipment to factory? .................................. 163