184 User’s Manual INNOMAR Parametric Sub-Bottom Profilers / SESWIN
184 Innomar Technologie GmbH (2023-01)
S/N starts with “E”
Dimensions (L×W×H) 60 cm × 50 cm × 20 cm
Weight in air about 90 kg (incl. 30 m cable)
about 110 kg (incl. 50 m cable)
Cable / Connector Diameter c. 22 mm / c. 54 mm
The pole-mount transducer (see previous page) is delivered without
the fairings and mounted into a shock-absorbing frame via an extra
flange to reduce structure-borne noise. This frame is mounted by 18
bolts M10 and is suitable for mounting the transducer directly to the
vessel’s hull (sea chest), into blisters or gondolas.
The cable is moulded non-removable to the transducer, the standard cable length is 30m.
To avoid biofouling reducing the system performance, permanently-mounted transducers
have to be coated using an INNOMAR approved anti-fouling paint. Please do not use any
other paint since this might destroy the transducer. We also recommend anti-fouling if a pole-
mounted transducer is operated in tropical waters for a longer period. See section 8.1.3 on page
117 for details.
Hull-Mount Transducer
Transducer mounting via 18 bolts M10
arranged on the mounting flange.
Make sure the correct orientation (arrow
pointing forward and notch in the skids)
for beam-steering.
To Next Page