retry to the same server,
send to a different
server, or give up. A
retry to the same server
is counted as a
retransmit as well as a
timeout. A send to a
different server is
counted as a Request as
well as a timeout.
• Other Info
This section contains information about the state of the server and the
latest round-trip time.
Name RFC4668
Name
Description
State - Shows the state of the server. It takes one
of the following values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP
communication is not yet up and running.
Ready: The server is enabled, IP
communication is up and running and the
RADIUS module is ready to accept access
attempts.
Dead (X seconds left): Access attempts
were made to this server, but it did not
reply within the configured timeout. The
server has temporarily been disabled, but
will get re-enabled when the dead-time
expires. The number of seconds left before
this occurs is displayed in parentheses. This
state is only reachable when more than
one server is enabled.
Round-Tr
ip Time
radiusAuthCli
entExtRoundT
ripTime
The time interval (measured in
milliseconds) between the most recent
Access-Reply/Access-Challenge and the
Access-Request that matched it from the
RADIUS authentication server. The
granularity of this measurement is 100 ms.
A value of 0 ms indicates that there hasn't
To Next Page
Loading...
Need help?
General
