-8P-2S:/>security network acl policy 1 2
Security Network ACL Rate
Description:
Set or show the ACL rate limiter.
Syntax:
Security Network ACL Rate [<rate_limiter_list>] [<rate_unit>] [<rate>]
Parameters:
<rate_limiter_list>: Rate limiter list (1-16), default: All rate limiters
<rate_unit> : IP flags: pps|kbps, default: pss
<rate> : Rate in pps (0-100) or kbps (0, 100, 2*100, 3*100, ..., 1000000)
Default Setting:
1
Example:
Set rate limit value in 100 for port 1
-8P-2S:/>security network acl rate 1 100
Security Network ACL Add
Description:
Add or modify Access Control Entry (ACE).
If the ACE ID parame
ter <ace_id> is speci
fied and an en
try wi
th this ACE ID already exists, the
ACE will be modified. Otherwise, a new ACE will be added. If the ACE ID is not specified, the next
available ACE ID will be used.
If the next
ACE ID parameter
<ace_id_nex
t> is specified,
the ACE w
ill be placed
before this ACE in the list. If the next ACE ID is not specified, the ACE will be placed last in the list.
If the Switch keyword is used, the rule applies to all ports.
To Next Page
Loading...
Need help?
General
