Interlogix IFS NS3502-8P-2S - 4.12 Security

IFS NS3502-8P-2S User Manual
275
4.12 Security
This section is to control the access of the Managed Switch, includes the user access and management
control.
The Security page contains links to the following main topics:
 Port Limit Control
 Access Management
 HTTPs / SSH
 DHCP Snooping
 IP Source Guard
 ARP Inspection
4.12.1 Port Limit Control
This page allows you to configure the Port Security Limit Control system and port settings.
Limit Control allows for limiting the number of users on a given port. A user is identified by a MAC
address and VLAN ID. If Limit Control is enabled on a port, the limit specifies the maximum number of
users on the port. If this number is exceeded, an action is taken. The action can be one of the four
different actions as described below.
The Limit Control module utilizes a lower-layer module, Port Security module, which manages MAC
addresses, learnt on the port.
The Limit Control configuration consists of two sections, a system- and a port-wide.
The Port Limit Control Configuration screen in Figure 4-12-1 appears.