5. COMMAND LINE INTERFACE
5.1 Accessing the CLI
When accessing the management interface for the switch over a direct connection to the server’s
console port, or via a Telnet connection, the switch can be managed by entering command keywords
and parameters at the prompt. Using the switch's command-line interface (CLI) is very similar to
entering commands on a UNIX system.
This chapter describes how to use the Command Line Interface (CLI).
Logon to the Console
Once the terminal has connected to the device, power on the Managed Switch, the terminal will
display that it is running testing procedures.
Then, the following message asks the login username & password. The factory default password as
following and the login screen in Figure 5-1 appears.
Username: admin
Password: admin
Figure 5-1: Managed Switch Console Login screen
1. For security
To Next Page
Loading...
Need help?
General
