Figure 5-3: Set IP address screen
4. Repeat Step 1 to check if the IP address is changed.
If the IP address is successfully configured, the Managed Switch will apply the new IP address setting
immediately. You can access the Web interface of Managed Switch through the new IP address.
If you do not familiar with console command or the related parameter, enter
“help” anytime in console to get the help description.
You can change these settings, if desired, after you log on. This management method is often preferred
because you can remain connected and monitor the system during system reboots. Also, certain error
messages are sent to the serial port, regardless of the interface through which the associated action
was initiated. A Macintosh or PC attachment can use any terminal-emulation program for connecting
to the terminal serial port. A workstation attachment under UNIX can use an emulator such as TIP
To Next Page
Loading...