GAPS - User Guide
10.1.3 CONNECTING A NEW GAPS BOX TO GAPS
The following procedure concerns the exchange of one GAPS BOX with another one.
1. Switch off the GAPS BOX and disconnect it.
2. Connect the new GAPS BOX to the GAPS. See section 3.3.
3. Turn on the GAPS BOX.
GAPS starts the configuration of the GAPS BOX.
4. Wait 30 seconds until the configuration of the GAPS BOX is completed.
5. Turn off and then on the GAPS BOX.
The GAPS is ready for operation.
MU-GAPS-AN-005-H - November 2019 159
To Next Page
Loading...
