iXBlue GAPS - Configuring the Telemetry

GAPS - User Guide
4.4.1.5 Configuring the Telemetry
Input
1. Click on the INSTALLATION > INPUTS.
2. Click on Telemetry to have access to the specific parameters.
3. In Input, select the Port between Serial A, B, C, D or Ethernet A, B, C, D.
4. In Protocol, select ITSTELEMETRY.
5. If you have selected Serial in step 3, enter the following parameters:
6. If you have selected Ethernet in step 3, enter the following parameters:
7. Click on OK to validate your input data configuration and send this data to the GAPS.
The ITSTELEMETRYprotocol is produced each time telemetry data is received.
MU-GAPS-AN-005-H - November 2019 69