GAPS - User Guide
The computer IP address used here takes into account that GAPS is using its default
configuration with its default IP address. You may change the IP address and subnet mask of
GAPS. In either case the subnet masks of both computer and GAPS must be identical.
If you have no idea on which IP address GAPS has been configured, you may recover this IP
address by connecting a HyperTerminal on the computer to one of the RS232 connector and
configuring the terminal to the following settings: 115200 bauds, 8, none, 1. The IP address is
then being broadcasted by GAPS on the HyperTerminal.
58 MU-GAPS-AN-005-H - November 2019
To Next Page
Loading...
