KDC User Manual SYNCHRONIZATION
177
KTSync will synchronize barcode data from KDC in burst mode. Otherwise, KTSync
would synchronize barcode data one by one. This option is enabled by default and
maynot be disabled.
• Synchronization on Connection
KTSync will automatically synchronize barcode data from the KDC when the KDC is
connected, if this option is enabled.
• Clear KDC Memory After Synchronization
KTSync clears barcode data stored in the KDC’s memory once synchronization has
finished, if this option is enabled.
• Append Data to File
KTSync appends synchronized data to existing file specified on destination. If file does
not exist then KTSync creates a new file.
Data Edition
• Attach Serial Number
The KTSync will add a KDC serial number to barcode data. This option is enabled by
default and maynot be disabled.
• Attach Time Stamp
The KTSync would add timestamp to barcode data. This option is enabled by default
and maynot be disabled.
• Attached Barcode Type
The KTSync would add barcode type to barcode data. This option is enabled by default
and maynot be disabled.
To Next Page
Loading...
