232
O
Oscillator Mode conflicts (check PROG P1)
P
Pattern conflicts with events
Pattern exists across destination to-end-of-measure or
source from-measure
Pattern exists in destination or source track
Open pattern ?
Pattern used in song Continue ?
R
Root directory is full
S
Sample data used in other sample(s) Continue ?
Sample L and R are identical
Sample length is shorter than minimum
Sample used in other multisample(s) Continue ?
Selected file/path is not correct
Source is empty
Source sample is empty
T
There is no readable data
U
Unable to create directory
Unable to save file
Meaning: In Sampling mode when you executed “Convert
MS To Program” with Use Destination Program
Parameters checked, the conversion destination
program “Oscillator Mode” setting did not match.
Action: In Program mode, set the “Oscillator Mode” of the
conversion destination program. If converting a
monaural multisample, select Single. If converting
a stereo multisample, select Double.
Meaning: It was not possible to execute the Bounce opera-
tion because one of the tracks contained a pattern,
and the same measure of the other track contained
events or a pattern.
Action: Open the pattern.
Meaning: When moving a measure, the edit operation could
not be executed because a pattern had been put in
the destination end measure or the source start
measure, and had not been opened.
Action: Open the pattern.
Meaning: A pattern has been placed in the track that you
specified as a destination or source for editing. If
you wish to open the pattern and execute (the
events of the pattern will be copied), press the OK
button. If you wish to execute without opening
the pattern, press the Cancel button.
Meaning: When editing, the specified pattern has been
placed in a track. If you wish to execute, press the
OK button. If you decide not to execute, press the
Cancel button.
Meaning: You attempted to create a file or directory in the
root directory of the media, but this would exceed
the maximum number of root directory entries.
Action: Either delete an existing file or directory, or
exchange media.
Meaning: Other sample(s) use the same sample data as the
sample that you are editing. To continue editing,
press the OK button.
Meaning: The edit operation could not be executed because
the destination (save location) L and R sample
numbers are identical.
Action: Select different sample numbers for L and R of the
destination (save location).
Meaning: You attempted to execute an editing operation
that would make the sample data shorter than 8
samples.
Action: Change the editing range so that the sample data
will be longer than 8 samples.
Meaning: The sample you are editing is used by other multi-
samples. To continue editing, press the OK button.
Meaning: When loading a KSF file that was split across mul-
tiple media, the order in which you attempted to
load the files was incorrect.
Action: Load the KSF file in the correct order. To view the
file number order in which the KSF files were
saved, you can check the “Translation” page
menu command. (The sample name and number
of the first KSF file will be displayed.)
Meaning: No data exists in the track or pattern that you
specified as the source.
Action: Specify a track or pattern that contains musical
data.
Meaning: When executing Insert, Mix, or Paste, the source
sample is empty.
Action: Execute the Copy operation before executing
Insert, Mix, or Paste.
Meaning: Either the file size is 0 or the file does not contain
data that can be accessed by the load or open
operation. Alternatively, the data is damaged etc.,
and cannot be loaded or accessed.
Meaning: You attempted to create a directory that would
exceed the maximum pathname length (76 charac-
ters for the full pathname).
Meaning: When executing the Disk mode Utility command
“Copy,” the copy destination path length
exceeded 76 characters.
Meaning: When saving a file in Disk mode or Song Play
mode, the save destination path exceeded 76 char-
acters.
To Next Page
Loading...
Need help?
General
