Leightronix MINI-T-NET - Illustration 10, Net Series Bootware Screen; Illustration 11, Net Series Controller Boot Progress Screens

NET Series
Controller Installation & Configuration
LEIGHTRONIX, INC. Firmware Ver. 1.00.42/Software Ver. 1.0.2.6 Page 23
2010-07-09
6. Screw the included power supply into the rear of the NET Series Controller, and
then plug it into an AC power source.
CAUTION
LEIGHTRONIX strongly recommends the use of a surge
protector/ uninterruptible power supply (UPS), as damage from
power loss or spikes is not covered under warranty.
The Controller will automatically boot up and display the following messages:
a. Initial boot up screen: gives the bootware version, memory size, and memory
check status (see Illustration 10, NET Series Bootware Screen).
Illustration 10, NET Series Bootware Screen
b. Boot up progress screens: give the NET Series Controller’s boot progress (see
Illustration 11, NET Series Controller Boot Progress Screens). During
initialization, any saved NET Series Controller settings and active schedule are
implemented.
Illustration 11, NET Series Controller Boot Progress Screens
LEIGHTRONIX, INC.
Boot 1.0.8 16MB ok
LEIGHTRONIX, INC.
Decompressing firmware..
LEIGHTRONIX, INC.
Executing firmware..
Initializing ...