NET Series
Software Installation and Configuration
Page 38 Firmware Ver. 1.00.42/Software Ver. 1.0.2.6 LEIGHTRONIX, INC.
2010-07-09
TASK
7. Perform the following WinNET setup tasks:
Set program settings (see “Setting WinNET Viewing and
Communication Options,” on page 63).
Set time zone and time (see “Configuring Site Information and Clock,
Updating Firmware, and Rebooting Controller,” on page 54).
NOTE: The time zone and time may also be set from the Controller’s
front panel (see “Setting Clock,” on page 27 and “Setting
Time Zone,” on page 28).
Read “Loading Controller Images,” on page 84, for more information on
image files. Open the sample image for your Controller type to see
examples of image contents.
Enter the Controller properties (see “Configuring Controller Properties,”
on page 67).
NOTE: The fallback configuration and the NET-EC’s external
switcher settings may also be set from the Controller’s front
panel (see “Configuring Fallback Setting,” on page 29 and
“Configuring Switcher,” on page 30).
Enter each device’s properties (see “Creating Device Resources,” on
page 72).
8. Check PRO-BUS interface, DVply, and switcher wiring by sending a
command to each device from the control panel as follows:
a. Select a device controlled by a PRO-BUS interface or DVply in the left-
hand “Device” column on the control panel window.
b. Send a command to the selected device from the “Device control”
section of the control panel and ensure the device itself responds
accordingly (see “Using Control Panel to Perform Immediate Device and
Switch Actions,” on page 112).
NOTE: To check video quality, switch your device to an output
connected to a monitor.
9. Pre-program any inputs not controlled by PRO-BUS or DVply under the
“Switch” tab (see “Creating Switch Resources,” on page 74).
10. Pre-program any media resources under the “Library” tab (see “Creating
Library Resources,” on page 76).
11. Begin creating a playlist of events (see “Software Operation,” on page 79).
To Next Page
Loading...
