NET Series
Software Installation and Configuration
Page 52 Firmware Ver. 1.00.42/Software Ver. 1.0.2.6 LEIGHTRONIX, INC.
2010-07-09
Edit user rights
1. Highlight the desired username and click “Edit.”
2. If desired, change username and/or password.
3. Check the user rights you want the user to be able to access and uncheck
the items you do not want the user to access.
4. Click “Ok” to send the new user settings to the Controller or “Cancel” to
abort the edit.
Delete a user
1. Highlight the desired username and click “Delete.”
2. In the dialog box that appears, click “Yes” to delete user or “No” to abort the
change.
Table 13, User Rights
USER RIGHTS DESCRIPTIONS
“Administrator” Allows user to change user account rights and perform firmware
updates and factory resets.
“Device (play,
rewind, stop)”
Allows user to cause a device to play, rewind, or stop.
“Device (record)” Allows user to cause a device to record.
“TCP/IP
configuration”
Allows user to set up the TCP/IP addresses.
“Schedule control
(includes switcher
config)”
Allows user to start and stop schedule with the “Schedule
Enable” command on the control panel. Also allows user to set
fallback settings in the “Control” tab of the “Properties” window.
NET-EC users may set up the number of switcher inputs/outputs
and levels and the switcher type.
“Switcher control” Allows user to perform switches from control panel.
“System
configuration and
control”
Allows user to set site information, set clock, update firmware,
and reboot Controller from the “Controller” window under the
“Tools” menu.
“System status” This is a default right that allows all users to view the Controller
status from the control panel.
3. When finished configuring user information, exit the “User Accounts” window by
clicking the “Close” button.
To Next Page
Loading...
