Manitowoc MLC650 - Page 96

OPERATING CONTROLS AND PROCEDURES MLC650 OPERATOR MANUAL
3-46
Published 08-12-19, Control # 224-13
All Rotating Carbody Jacks (at same
time)
• Select and confirm item 15.
• Move the control handle I either in direction to energize the function.
• Move the control handle II FORWARD to EXTEND all of the jacks or move
the control handle II REARWARD to RETRACT all of the jacks.
Individual Carbody Jack
• Select and confirm item 16.
• Move the control handle I in the required direction to select the desired jack.
• Move the control handle II FORWARD to EXTEND the jack or move the
control handle II REARWARD to RETRACT the jack.
Adapter Frame to Rotating Bed Pins,
Front
• Select and confirm item 17.
• Move the control handle I in either direction to energize the function.
• Move the control handle II FORWARD to ENGAGE the front rotating bed pins
or move the control handle II REAWARD to DISENGAGE the front rotating
bed pins.
Rotating Bed to Adapter Frame Pins,
Rear
• Select and confirm item 18.
• Move the control handle I in either direction to energize the function.
• Move the control handle II FORWARD to ENGAGE the rear rotating bed pins
or move the control handle II REAWARD to DISENGAGE the rear rotating
bed pins.
Live Mast Assist Arms
• Select and confirm item 19.
• Move the control handle I in either direction to energize the function.
• Move the control handle II FORWARD to EXTEND the mast assist arms and
cylinders or move the control handle II REARWARD to RETRACT the mast
assist arms and cylinders.
Crawler Pins, Left
• Select and confirm item 20.
• Move the control handle I in either direction to energize the function.
• Move the control handle II FORWARD to ENGAGE the left crawler pins or
move the control handle II REAWARD to DISENGAGE the left crawler pins.
Crawler Pins, Right
• Select and confirm item 21.
• Move the control handle I in either direction to energize the function.
• Move the control handle II FORWARD to ENGAGE the right crawler pins or
move the control handle II REAWARD to DISENGAGE the right crawler pins.
Counterweight Tray, In/Out
• Select and confirm item 22.
• Move the control handle I in either direction to energize the function.
• Move the control handle II FORWARD to travel the counterweight tray OUT
or move the control handle II REARWARD to travel the counterweight tray IN.
VPC-MAX Trolley to Beam Pins
• Select and confirm item 23.
• Move the control handle I in either direction to energize the function.
• Move the control handle II
FORWARD to ENGAGE the pins or move the
control handle II REARWARD to DISENGAGE the pins.
VPC-MAX Beam Travel, In/Out
• Select and confirm item 24.
• Move the control handle I in either direction to energize the function.
• Move the control handle II FORWARD to travel the beam OUT or move the
control handle II REARWARD to travel the beam IN.
Table 3-15. Identification and Operation of Remote Controls