3A-2390-13645--2 495 FUEL SYSTEM AND CARBURETION
S Install stem gasket.
S Install fuel bowl gasket.
51119
a
b
a - Stem Gasket
b - Fuel Bowl Gasket
NOTE:
If spring clip on inlet needle was removed, or
if needle was replaced, be sure spring clip is
reattached.
S Attach spring clip on inlet needle to metal float tab
and place needle into its seat.
51115
a
b
a - Spring Clip
b - Float Tab
S Install float into carburetor with float pin.
S Adjust float following “Float Adjustment,” Page
3A-18.
51115
a
b
a - Float
b - Float Pin
S Install float bowl.
51116
a
b
b
a - Float Bowl
b - Screw (4) Torque 18 lb. in. (2.1 Nm)
IDLE AIR SCREW
Idle air screw is preset by the manufacturer and is
NOT for field service. If the idle air screw should be-
come misadjusted, set air screw at 1/4 TURN OUT
from a LIGHTLY SEATED position.
51620
a
a - Idle Air Screw
To Next Page
Loading...
