Mariner 80 - Ride-Guide Steering Cable and Pivot Points Lubrication

1-790-13645--2 495 GENERAL INFORMATION AND SPECIFICATIONS
Lubrication Points
No. Description
Lubricant Used or
Maintenance
Fresh Water Frequency Salt Water Frequency
1 Ride-Guide
Steering Cable
2 Throttle-Shift
Linkage
Quicksilver
C
E60D
E30D
3 Upper Shift Shaft
2-4-C
w/Teflon
Every 60 Days Every 30 Days
4 Tilt Tube
w
/T
e
fl
on
5 Swivel Pin
6 Tilt Lock Lever
7 Propeller Shaft
Quicksilver
-2-4-C w/Teflon
Anti-Corrosion Grease
Once in Season Every 60 Days
8 Gear Housing Quicksilver Gear Lube
Check and fill after 1st 10 days, then every 30 days
Drain and Refill after 1st 25 hours, then after every
100 hours, or once a year before storing.
9
Steering Link Rod
Pivot Points
SAE 30W Engine Oil Every 60 Days Every 30 Days
10
Power Trim Pump
Oil Level
Quicksilver Power Trim
and Steering Fluid
Every 100 hours,
or once in season
Same as Fresh Water
--- Engine Crankshaft
Splines to Drive
Shaft Splines
Quicksilver
2-4-C w/Teflon
Once in Season by Dealer
11
Accelerator Pump
Stem/Throttle Cam
Quicksilver 2-4-C
w/Teflon
Once in Season Every 60 Days
27868
7
8
20319
6
10
5
Ride-Guide Steering Cable and Pivot
Points Lubrication
WARNING
Core of steering cable (transom end) must be fully
retracted into cable housing before lubricating
cable. If cable is lubricated while extended,
hydraulic lock of cable could occur.
With core of Ride-Guide Steering cable (transom
end) fully retracted, lubricate transom end of steering
cable thru grease fitting and exposed portion of cable
end with Quicksilver 2-4-C w/Teflon. Lubricate all piv-
ot points with SAE 30W engine oil.
50099
1
4
9