6A-31POWER TRIM90-13645--2 495
7. Insert shaft into housing, as shown.
51342
Tap shaft into housing until shaft is positioned as
shown.
51365
DANGER
Cup will be expelled from housing at a high
velocity when air pressure is applied. Failure to
place housing as shown could result in severe
personal injury or death.
8. Place housing, as shown.
Hold down on housing and inject air into shaft
opening, as shown.
Reinstall allen plug into shaft.
51353
a
b
c
a - Shop Cloth
b - Solid Work Bench (or Floor)
c - Air Nozzle
CLEANING AND INSPECTION
Inspect O-rings, and replace if damaged.
Clean components with parts cleaner and dry with
compressed air.
Inspect tilt rod. If scraper (located in cap) has failed to
keep rod clean, replace scraper; refer to instructions,
following.
SCRAPER REPLACEMENT
Use a screwdriver to remove components from cap.
a
c
d
e
b
b
a - Cap
b - O-ring (2)
c - Scraper Seal
d - Washer
e - Retaining Ring
To Next Page
Loading...
