Metronix smartServo BL 4104-C User Manual

Table of Contents
7.2 Oscilloscope 120
7.2.1 Oscilloscope window 120
7.2.2 Oscilloscope settings 122
7.2.2.1 Tabs: CH1 ... CH8 122
7.2.2.2 Tabs: Time base 124
7.2.2.3 Tabs: Trigger 125
7.3 Display units 126
7.3.1 User-defined display units 126
7.3.2 Direct input of the display units 127
7.4 Parameter sets 128
7.4.1 Online parameterisation: Overview 128
7.4.2 Loading and saving parameter sets 129
7.4.3 Offline parameterisation: 130
7.4.4 Parameterisation via a microSD card 131
7.5 Angle encoder settings 134
7.5.1 "Commutating-generator" tab 134
7.5.2 "X2A" tab 135
7.5.3 "X2B/X6" tab 136
7.5.3.1 General settings 137
7.5.3.2 Digital incremental encoders 139
7.5.3.3 Analogue incremental encoders 141
7.5.3.4 Serial:EnDat2.2 143
7.5.3.5 Serial:HIPERFACE 144
7.5.3.6 Serial:HIPERFACEDSL 145
7.5.3.7 Serial:BiSS 146
7.5.3.8 Storing parameters in the encoder 148
7.5.4 "X1" tab 151
7.6 Parameterisation of the motor and output stage 153
7.6.1 Methods for analysing motor problems 153
7.6.2 Configuration of the output stage 154
7.6.3 Use of linear motors 154
Product manual BL 4000-C Page 8 of 298

Metronix smartServo BL 4104-C Specifications

General

Brand	Metronix
Model	smartServo BL 4104-C
Category	Servo Drives
Language	English