Midas PRO2 User Manual

334 Appendix E: Updating The PRO2 Host Software
PRO2 Live Audio System
Owner’s Manual
7 Click Upgrade now. A window will open asking if you would like to back up your
shows.
8 Click No Thank You to start the upgrade. (If, at this point, you want to back up
your shows and preferences, click Yes Please.) The device blocks will change
colour according to their update status (see “Device blocks” on page 331). The
green bar at the bottom will show the progress of the current action. A typical
screen display during the update procedure is shown in Figure 29 “A typical
updater display” on page 330.
During the upgrade, leave all of the system devices switched on.
9 When the upgrade procedure has
finished, you will see the
“Upgrade complete” message
(shown right).
Do not switch off the power until the console has fully rebooted.

Midas PRO2 Specifications

General

Sample Rate	96 kHz
Talkback	Yes
MIDI I/O	Yes
Computer Connectivity	USB, Ethernet
Processing	40-bit floating point
Recallable Preamps	Yes
Channels	64
Matrix	8 matrix buses
Display	15" TFT display
Connectivity	Ethernet, MIDI
Type	Digital
EQ Bands	4-band parametric EQ
Inputs - Mic Preamps	8 XLR
Outputs - Main	8 XLR
Effects	Reverb, Delay, Modulation, etc.
Dynamic Processing	Gate, Compressor, Limiter
Control Surface	Motorized faders, touchscreen
Power Supply	Internal