Midas PRO2 User Manual

Using the PRO2 updater 335
PRO2 Live Audio System
Owner’s Manual
10 Click Quit and reboot to exit the
updater and automatically reboot
the PRO2. (You can exit the
updater later by clicking Quit
later.)
The GUI will display the screen
shown right.
Do not switch off the power
until the console has fully
rebooted.
11 When the PRO2 has fully rebooted, power cycle the system (including all I/O
boxes) to restart using the new software. Do this by powering the system down
and then powering it up again (see “Powering the PRO2 system” on page 30).

Midas PRO2 Specifications

General

Sample Rate	96 kHz
Talkback	Yes
MIDI I/O	Yes
Computer Connectivity	USB, Ethernet
Processing	40-bit floating point
Recallable Preamps	Yes
Channels	64
Matrix	8 matrix buses
Display	15" TFT display
Connectivity	Ethernet, MIDI
Type	Digital
EQ Bands	4-band parametric EQ
Inputs - Mic Preamps	8 XLR
Outputs - Main	8 XLR
Effects	Reverb, Delay, Modulation, etc.
Dynamic Processing	Gate, Compressor, Limiter
Control Surface	Motorized faders, touchscreen
Power Supply	Internal