Mitel 6940w - Outgoing Redial Key; Configuring an Outgoing Redial Key Using the Mitel Web UI

134
C
ONFIGURING SOFTKEYS OUTGOING REDIAL KEY
Outgoing Redial Key
By default, the 6940 has a dedicated Outgoing Redialkey. However, using the Mitel Web UI, you can
assign the Outgoing Redialkey to any key on the top or bottom keys on the phone.
The Outgoing Redial List is a stored log of your outgoing calls. You can use the Outgoing Redial key to
access a list of the most recent calls you placed.
NOTE: For more information about the Outgoing Redial List, see “Outgoing Redial List” on page 143.
Configuring an Outgoing Redial Key Using the Mitel Web UI
1. Click on Operation > Softkeys and XML.orClick on Operation > Expansion Module <N>.
Softkeys
2. Select from Key 1 through Key 48 on the Top keys.orSelect from Key 1 through Key 30 on the Bottom
keys.
3. In the Type field, selectRedial.
4. In the Label field, enter a label to apply to this key.
5. In the state fields, check (enable) or uncheck (disable) the states you want to apply to this softkey.