148
U
SING INTERCOM FUNCTIONALITY USING THE ICOM KEY
Using Intercom Functionality
On the 6940 you can use the Icom key to automatically connect with a remote extension.
Using the Icom Key
1. Press the Icom key.
2. If no number was defined when configuring the key, enter the extension number of the person you
want to intercom.
3. After a beep tone, your phone automatically connects with the remote extension and you can speak
through its speaker.
4. To cancel the intercom, press or the Cancel key.
5. When you are finished speaking, hang up the phone by placing the handset back on-hook or by
pressing or the line/call appearance button for the active call. When you hang up, the remote
phone also hangs up.
You can set specific incoming Intercom call features on the 6940 IP phone using the Mitel Web UI. The
following table describes these features.
NOTE: For more information about the incoming Intercom features and for procedures on setting these
features, see “Incoming Intercom Call Features” on page 217.
Incoming Intercom Features in Mitel Web UI Description
Microphone Mute Allows you to enable or disable the microphone
on the IP phone for Intercom calls made by the
originating caller.
Auto Answer Allows you to enable or disable the IP phone to
automatically answer an Intercom call. If
auto-answer is enabled on the IP phone, the
phone plays a tone (if Play Warning Tone is
enabled) to alert the user before answering the
intercom call. If auto-answer is disabled, the
phone treats the incoming intercom call as a
normal call.
Play Warning Tone Allows you to enable or disable a warning tone to
play when the phone receives an incoming
intercom call on an active line.
Allow Barge In Allows you to enable or disable how the phone
handles incoming intercom calls while the phone
is on an active call.
To Next Page
Loading...
