Mold-Masters M2 - Page 177

© 2014 Mold-Masters (2007) Limited. All Rights Reserved.
Revised 1 Oct, 2014
i
www.moldmasters.com
Index
A
Alarms 6-18
Alarm Time 5-10
Alias 5-9
Allow Global Set 5-18
Allow Standby 5-18
Allow ToolLoad 5-18
Auto-follow Startup 5-16
B
Back-up tool settings 6-33
Baud Rate 5-18
Blanking Delay 5-18
Boost Temperature 5-9
Boost Time 5-9
Button One & Two Modes 5-13
C
Calibrate Touch 5-18
Card Indicators 6-20
Cards that may be detected 5-4
Change Temperatures on Display Page 6-6
Change temperatures on Easyview page 6-10
Check past performance 6-14
Congure Control Cards 5-6, 5-7
Control Modes 6-2
Create a new tool 6-24
D
Delete a tool 6-32
Display Group 5-11
Display Mode 5-13
E
EasyView - about 6-9
Energy Page 5-41
Event Log Page 6-16, 6-17
Export Facility 7-5
F
Fault and warning messages 8-1
Flow Units 5-13
Fuses 8-9
G
Ground Fault Limit 5-19
I
Input/Output Card: (IO4) 6-44
Input Signal 5-14
Input Timer 5-13
IO5 card for Remote Tool Selection 6-48
L
Limit Exceeded 5-19
Load a Picture image 6-40
Load tool settings 6-29
Locally connected printer 5-42
Log in 6-2
Log Out 6-2
M
Master Follow 5-16
Master Only Startup 5-16
Master Zone 5-9
Maximum & Minimum Settings 5-10
N
Network Printer 5-42
N/Z Alarm 5-19
P
Picture Page 6-39
Power Alarm Delay 5-14
Power Display 5-19
Power Mode 5-14
Pressure Units 5-14
Print Out Facility 7-2
Print out to File 7-2
Print to a USB Memory Stick 5-42
Purge Mode 5-14
Purge parameters - setting 6-13