5 - 40 WiNG 5.6 Access Point System Reference Guide
32. Select the Security tab.
Figure 5-26 Virtual Interfaces - Security tab
33. Use the IPv4 Inbound Firewall Rules drop-down menu to select the IPv4 specific inbound firewall rules to apply to this
profile’s virtual interface configuration. Select the Create icon to define a new IPv4 firewall rule configuration or select the
Edit icon to modify an existing configuration.
IPv4 is a connection less protocol for packet switched networking. IPv4 operates as a best effort delivery method, since it
does not guarantee delivery, and does not ensure proper sequencing or duplicate delivery (unlike (TCP).
IPv4 and IPv6 are different enough to warrant separate protocols. IPv6 devices can alternatively use stateless address
autoconfiguration. IPv4 hosts can use link local addressing to provide local connectivity.
Use the IPv6 Inbound Firewall Rules drop-down menu to select the IPv6 specific inbound firewall rules to apply to this
profile’s virtual interface configuration. Select the Create icon to define a new IPv6 firewall rule configuration or select the
Edit icon to modify an existing configuration.
IPv6 is the latest revision of the Internet Protocol (IP) replacing IPv4. IPV6 provides enhanced identification and location
information for systems routing traffic across the Internet. IPv6 addresses are composed of eight groups of four
hexadecimal digits separated by colons.
34. Use the VPN Crypto Map drop-down menu to select and assign a VPN crypto map entry to this virtual interface. The VPN
Crypto Map entry defines the type of VPN connection and its parameters. For more information, see Defining Profile VPN
Settings on page 5-131.
35. Select the OK button located at the bottom right of the screen to save the changes to the Security screen. Select Reset to
revert to the last saved configuration.
5.2.5.3 Port Channel Configuration
Profile Interface Configuration
The access point’s profile can be applied to customize the port channel configurations as part of its interface configuration.
To define a port channel configuration for an access point profile:
To Next Page
Loading...
