Motorola WiNG 5.6 - Event History Messages

14 - 2 WiNG 5.6 Access Point System Reference Guide
14.1 Event History Messages
To review event history messages:
1. Select Configuration > Diagnostics > Fault Management > Event History to display the Event History screen.
2. Select Fetch Historical Events to display the diagnostic events in the Event History table.
3. Refer to the following (read only) information to assess logged diagnostic events.
ADOPT-SERVICE SNMP_SUCCESS 6 SNMP framework success
ADOPT-SERVICE SNMP_FAILURE 6 SNMP framework failure
ADOPT-SERVICE
TUT_TEMPERATURE_ALARM_RAISED ([str])
Temperature alarm raised on sensor
ADOPT-SERVICE
TUT_TEMPERATURE_ALARM_CLEARED ([str])
Temperature alarm cleared on sensor
ADOPT-SERVICE TUT_TEMPERATURE_ALARM_CLEARED
([str])
Temperature alarm cleared on sensor
ADOPT-SERVICE TUT_FAN_ALARM_CLEARED 5 IPX ([str]) Fan alarm cleared on ID
ADOPT-SERVICE TUT_PWRCTRL_ALARM_RAISED 5 IPX
([str])
Power controller alarm raised
ADOPT-SERVICE TUT_PWRCTRL_ALARM_CLEARED 5 IPX
([str])
Power controller alarm cleared
ADOPT-SERVICE TUT_LINE_POWER_ALARM_RAISED 5 IPX
([str]) Line power alarm raised on id [str]
Line power alarm raised
ADOPT-SERVICE TUT_LINE_POWER_ALARM_CLEARED 5
IPX ([str]) Line power alarm cleared on id [str]
Line power alarm cleared
ADOPT-SERVICE TUT_WLAN_CLIENT_ASSOC 6 IPX ([str])
Client [str] on interface index [str] associated
Client associated
ADOPT-SERVICE TUT_WLAN_CLIENT_DISASSOC 6 IPX ([str])
Client [str] on interface index [str] disassociated with status
code [str], [str]
Client disassociated
ADOPT-SERVICE TUT_WLAN_CLIENT_ASSOC_FAILURE 3
IPX ([str]) Association failed for Client [str] on interface index
[str] with status code [str], [str]
Association failed for client on specified interface index
ADOPT-SERVICE TUT_WLAN_CLIENT_AUTH 6 IPX ([str]) Client on interface index authenticated
ADOPT-SERVICE TUT_WLAN_CLIENT_DEAUTH 6 IPX ([str]) Client on interface index deauthenticated with status code
ADOPT-SERVICE TUT_WLAN_CLIENT_AUTH_FAILURE 3 IPX
([str])
Authentication failed for client on interface index with status
code
ADOPT-SERVICE TUT_RADIO_ADAPTIVE_POWER_CHANGE
5 IPX ([str])
Interface with operational status and power levels
ADOPT-SERVICE TUT_RF_MONITOR_MODE_CHANGE 5 IPX
([str])
RF monitor status changed to on interface