Quick Start 3 - 25
3.1.2.2 LAN Configuration
Advanced Setup Wizard
Use the LAN Configuration screen to configure the parameters required for setting a Local Area Network (LAN) on the access
point.
Figure 3-16 Initial Setup Wizard - LAN Configuration screen for Advanced Setup Wizard
1. Set the following DHCP and Static IP Address/Subnet information for the LAN interface:
• Use DHCP - Select the option to enable an automatic network address configuration using DHCP server.
• Static IP Address/Subnet - Enter an IP Address and a subnet for the access point's LAN interface. If Use DHCP is
selected, this field is not available. When selecting this option, define the following DHCP Server and Domain Name
Server (DNS) resources, as those fields will become enabled on the bottom portion of the screen.
• Default Gateway - Define a default gateway address for use with the static IP address configuration. This is a re-
quired parameter.
• Use on-board DHCP server to assign IP addresses to wireless clients - Select the check box to enable the
access point’s DHCP server to provide IP and DNS information to clients on the LAN interface.
• Range - Enter a starting and ending IP Address range for client assignments on the access point's LAN interface.
Avoid assigning IP addresses from x.x.x.1 - x.x.x.10 and x.x.x.255, as they are often reserved for standard network
services. This is a required parameter.
To Next Page
Loading...
