Quick Start 3 - 5
6. Select Save/Commit within each page to save the updates made to that page's configuration. Select Next to proceed to
the next page listed in the Navigation Panel. Select Back to revert to the previous screen without saving your updates.
The following sections describe the two different wizards and their parameters. The available wizards are:
• Typical Setup Wizard
• Advanced Setup Wizard
3.1.1 Typical Setup Wizard
Using the Initial Setup Wizard
The Typical Setup is the recommended wizard. This wizard uses default parameters for most of the configuration parameters
and creates a working network with the fewest steps.
The Typical Setup wizard consists of the following:
• Network Topology Selection
• LAN Configuration
• WAN Configuration
• Wireless LAN Setup
• Summary And Commit Screen
To configure the access point using the Typical Setup Wizard:
1. Select Typical Setup from the Choose One type to Setup the Access Point field.
2. Select Next.
The Initial Setup Wizard displays the Access Point Settings screen to define the access point's Standalone versus Virtual
Controller AP functionality. This screen also enables selection of the country of operation for the access point.
NOTE: While you can navigate to any page in the navigation panel, you cannot complete
the Initial Setup Wizard until each task in the Navigation Panel has a green check mark.
To Next Page
Loading...
