Statistics 13 - 99
4. Refer to the General field to assess the Monitor Interval used to poll for updates from critical resources and the Source
IP For Port-Limited Monitoring of critical resources.
The access point Critical Resource screen displays the following:
13.3.18 LDAP Agent Status
Access Point Statistics
When LDAP has been specified as an external resource (as opposed to local access point RADIUS resources) to validate PEAP-
MS-CHAP v2 authentication requests, user credentials and password information needs to be made available locally to
successfully connect to the external LDAP server. Up to two LDAP Agents (primary and secondary external resources) can be
defined as external resources for PEAP-MS-CHAP v2 authentication requests.
AP6511 and AP6521 model access point do not support this feature in Standalone AP or Controller AP mode. However, AP6511
and AP6521 models are supported when adopted and managed by a controller or service platform.
For more information on setting LDAP agents as part of the RADIUS server policy, see Configuring the RADIUS Server on page
9-46.
To view access point LDAP agent statistics:
1. Select the Statistics menu from the Web UI.
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF Domain and select one of its
connected access points.
3. Select LDAP Agent Status.
Critical Resource
Name
Lists the name of the critical resource monitored by the access point. Critical resources are
device IP addresses on the network (gateways, routers etc.). These IP addresses are critical to
the health of the network. These device addresses are pinged regularly by access points. If
there’s a connectivity issue, an event is generated stating a critical resource is unavailable.
Via Lists the VLAN used by the critical resource as a virtual interface. The critical resource displays
as a link than can be selected to list configuration and network address information in greater
detail.
Status Defines the operational state of each listed critical resource VLAN interface (either Up or
Down).
Error Reason Provides an error status as to why the critical resource is not available over its designated
VLAN.
Mode Displays the operational mode of each listed critical resource.
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.
To Next Page
Loading...
