Device Configuration 5 - 215
7. Refer to the SMART Scan field to review the settings defined for SMART RF. Optionally assign/remove overrides to and
from specific parameters.
8. Refer to the Client Name table to view the clients connected to RF Domain member access points adopted by networked
controllers or service platforms. Use the table to associate administrator assigned client names to specific connected client
MAC addresses for improved client management.
Enter the client’s factory coded MAC address in the MAC Address field. Assign a name to the RF Domain member access
point’s connected client to assist in its easy recognition in the Name field.
9. Select OK to save the changes and overrides made to the RF Domain configuration. Selecting Reset reverts the screen to
its last saved configuration.
5.4.4 Wired 802.1X Overrides
Overriding a Device Configuration
802.1X provides administrators secure, identity based access control as another data protection option to utilize with a device
profile.
802.1X is an IEEE standard for media-level (Layer 2) access control, offering the capability to permit or deny network
connectivity based on the identity of the user or device.
1. Select the Configuration tab from the Web UI.
2. Select Devices.
3. Select Device Overrides from the options on left-hand side of the UI.
4. Select a target device from the device browser in the lower, left-hand, side of the UI.
5. Select Wired 802.1x.
Figure 5-142 Profile Wired 802.1X screen
Enable Dynamic Channel Select the option to enable dynamic channel scan.
2.4 GHz Channels Use the Select drop-down menu to select channels to scan in the 2.4 GHz band. Selected
channels are highlighted with a grey background. Unselected channels are highlighted
with a white background. Multiple channels can be selected at the same time.
5.0 GHz Channels Use the Select drop-down menu to select channels to scan in the 5.0 GHz band. Selected
channels are highlighted with a grey background. Unselected channels are highlighted
with a white background. Multiple channels can be selected at the same time.
To Next Page
Loading...
