5 - 68 WiNG 5.6 Access Point System Reference Guide
6. Set the following parameters to define the ARP configuration:
7. Select the OK button located at the bottom right of the screen to save the changes to the ARP configuration. Select Reset
to revert to the last saved configuration.
Switch VLAN Interface Use the spinner control to select a VLAN for an address requiring resolution.
IP Address Define the IP address used to fetch a MAC Address.
MAC Address Displays the target MAC address that’s subject to resolution. This is the MAC used for
mapping an IP address to a MAC address that’s recognized on the network.
Device Type Specify the device type the ARP entry supports (Host, Router or DHCP Server). Host is the
default setting.
To Next Page
Loading...
