Motorola WiNG 5.6 - Page 184

5 - 98 WiNG 5.6 Access Point System Reference Guide
27. Use the drop-down menu to define the Bonjour Gateway Discovery Policy. Bonjour is Apple’s service discovery
protocol.
28. Select OK to save the changes to the basic configuration. Select Reset to revert to the last saved configuration.
29. Select the IPv4 tab to set IPv4 settings for this virtual interface.
IPv4 is a connection less protocol. It operates on a best effort delivery model that does not guarantee delivery or assures
proper sequencing or avoidance of duplicate delivery (unlike TCP).
Figure 5-59 Network - OSPF Virtual Interfaces - Basic Configuration screen - IPv4 tab
30. Set the following network information from within the IPv4 Addresses field:
No MTU Select this option to not use the existing MTU setting for router advertisements on this virtual
interface. If the value is set to zero no MTU options are sent. This setting is disabled by
default.
No Hop Count Select this option to not use the hop count advertisement setting for router advertisements
on this virtual interface. This setting is disabled by default.
Enable Zero
Configuration
Zero configuration can be a means of providing a primary or secondary IP addresses for the
virtual interface. Zero configuration (or zero config) is a wireless connection utility included
with Microsoft Windows XP and later as a service dynamically selecting a network to connect
based on a user's preferences and various default settings. Zero config can be used instead
of a wireless network utility from the manufacturer of a computer's wireless networking
device. This value is set to None by default.
Primary IP Address Define the IP address for the VLAN associated Virtual Interface.
Use DHCP to Obtain IP Select this option to allow DHCP to provide the IP address for the Virtual Interface. Selecting
this option disables the Primary IP address field.