5 - 178 WiNG 5.6 Access Point System Reference Guide
12. Click the Path Method Root Path Metric tab to configure the parameters controlling the calculation of the root path
metrics.
Figure 5-119 Mesh Point Auto Channel Selection Path Method Root Path Metric screen
Signal Threshold Configure the signal to noise threshold value for path selection.
When the signal strength of the next hop in the mesh network goes below this value, a
scan is triggered to select a better next hop.
Off-channel Duration Configure the duration in the range of 20 - 250 milliseconds for the Off Channel Duration
field. This is the duration that the scan dwells on each channel when performing an off
channel scan.
To Next Page
Loading...
