Device Configuration 5 - 223
11. Define the Offline Duration for this device. This is the time duration in minutes after which an unadopted device generates
a offline event.
12. Use the spinner control to set the Controller VLAN.
This is the VLAN the Virtual Controller is reachable on. Select from 1 - 4094. There is no default value for this setting.
13. Use the + Add Row button to populate the Controller Hostnames table with the following host, pool and routing
parameters for defining the preferred adoption resource.
14. Select OK to save the changes and overrides made to the access point adoption configuration. Select Reset to revert to
the last saved configuration.
Host Use the drop-down menu to specify whether the controller adoption resource is defined
as a (non DNS) IP address or a hostname. Once defined, provide the numerical IP or
hostname. A hostname cannot exceed 64 characters.
Pool Use the spinner controller to set a pool of either 1 or 2. This is the pool the target Virtual
Controller belongs to. The default setting is 1.
Routing Level Use the spinner controller to set the routing level for the Virtual Controller link. The
default setting is 1.
IPSec Support Select to enable secure communication between the access point and the wireless
controllers.
IPSec GW Use the drop-down menu to specify if the IPSec Gateway resource is defined as a (non
DNS) IP address or a hostname. Once defined, provide the numerical IP or hostname. A
hostname cannot exceed 64 characters.
Force Select to enable the link to the adopting controller or the controller group to be created
even when not required.
To Next Page
Loading...
