Device Configuration 5 - 263
Figure 5-170 Device Overrides - PPPoE screen
6. Use the Basic Settings field to enable PPPoE and define a PPPoE client:
Enable PPPoE Select Enable PPPoE to support a high speed client mode point-to-point connection using
the PPPoE protocol. The default setting is disabled.
Service Enter the 128 character maximum PPPoE client service name provided by the service
provider.
DSL Modem Network
(VLAN)
Use the spinner control to set the PPPoE VLAN (client local network) connected to the DSL
modem. This is the local network connected to DSL modem. The available range is 1 -
4,094. The default VLAN is VLAN1.
Client IP Address Provide the numerical (non hostname) IP address of the PPPoE client.
To Next Page
Loading...
