5 - 286 WiNG 5.6 Access Point System Reference Guide
3. Select a target device from the device browser in the lower, left-hand, side of the UI.
4. Select Network to expand its sub menu options.
5. Select Routing. The IPv4 Routing screen displays by default.
Figure 5-184 Device Overrides - Network - Network Routing screen
6. Select the IP Routing option to enable IP routing using static routes provided in the route table. This option is enabled by
default.
7. Select the Policy Based Routing policy to apply to this profile. Click the Create icon to create a policy based route or
click the Edit to edit an existing policy after selecting it in the drop-down list. For more information on policy based routing,
see Policy Based Routing (PBR) on page 7-2.
8. Select Add Row + as needed to include single rows with in the static IPv4 route table.
9. Add IP addresses and network masks in the Network column.
10. Provide the Gateway used to route traffic.
To Next Page
Loading...
