5 - 366 WiNG 5.6 Access Point System Reference Guide
Figure 5-247 Mesh Point Auto Channel Selection Path Method Root Path Metric screen
11. Refer to the following for more information on the Path Method Root Path Metric screen. These descriptions apply to
both the 2.4 GHz and 5.0/4.9 GHz frequencies.
Channel Width Configure the channel width that mesh point automatic channel scan should assign to the
selected radio. The available options are:
• Automatic – Indicates the channel width is calculated automatically. This is the
default value.
• 20 MHz – Indicates the width between two adjacent channels is 20 MHz.
• 40 MHz – Indicates the width between two adjacent channels is 40 MHz.
Priority Meshpoint Configure the mesh point to be monitored for automatic channel scan. This is the mesh
point that given priority over other available mesh points. When configured, a mesh is
created with this mesh point. When not configured, a mesh point is automatically
selected. The default is <none>.
Meshpoint: Path
Minimum
Configure the minimum path metric value for a mesh connection. Set a value between
100 - 20,000.
To Next Page
Loading...
