Wireless Configuration 6 - 83
22. Set the following Dynamic Sample Recovery parameters:
23. Select OK to update the Smart RF Neighbor Recovery settings. Select Reset to revert to the last saved configuration.
24. Select the Interference Recovery tab.
Figure 6-36 SMART RF Recovery Configuration screen - Interference Recovery tab
25. Set the following Interference Recovery parameters:
Dynamic Sample
Enabled
Select this option to enable dynamic sampling. Dynamic sampling enables an
administrator to define how Smart RF adjustments are triggered by locking retry and
threshold values. This setting is disabled by default.
Dynamic Sample Retries Use the spinner control to set the number of retries (1 - 10) before a power change is
allowed to compensate for a potential coverage hole. The default setting is 3.
Dynamic Sample
Threshold
Use the spinner control to set the number of sample reports (1 - 30) used before dynamic
sampling is invoked for a potential power change adjustment. The default setting is 5.
Interference Select this radio button to allow Smart RF to scan for excess interference from supported
radio devices. WLANs are susceptible to sources of interference, such as neighboring
radios, cordless phones, microwave ovens and Bluetooth devices. When interference for
WiFi sources is detected, Smart RF supported devices can change the channel and move to
a cleaner channel. This feature is enabled by default.
Noise Select this radio button to allow Smart RF to scan for excess noise from WiFi devices. When
detected, Smart RF supported access points can change their channel and move to a cleaner
channel. This feature is enabled by default.
To Next Page
Loading...
