Wireless Configuration 6 - 85
28. Set the following Coverage Hole Recovery for 5.0 GHz and 2.4 GHz parameters:
29. Select OK to update the Smart RF Coverage Hole Recovery settings for this policy. Select Reset to revert to the last saved
configuration.
Client Threshold Use the spinner to set a client threshold from 1 - 255. This is the minimum number of
clients a radio should have associated for coverage hole recovery to trigger. AP6522,
AP6522M, AP6532, AP6562, AP8132, AP8232 and AP71XX model access points can
support up to 256 clients per access point or radio. AP6511 and AP6521 model access
points can support up to 128 clients per access point or radio. The default setting is 1.
SNR Threshold Use the spinner control to set a signal to noise (SNR) threshold (from 1 - 75 dB). This is the
SNR threshold for an associated client as seen by its associated AP radio. When
exceeded, the radio increases its transmit power to increase coverage for the associated
client. The default value is 20 dB.
Coverage Interval Define the interval when coverage hole recovery should be initiated after a coverage hole
is detected. The default is 10 seconds for both 2.4 GHz and 5.0 GHz radios.
Interval Define the interval coverage hole recovery should be conducted after a coverage hole is
detected. The default is 30 seconds for both 2.4 GHz and 5.0 GHz radios.
To Next Page
Loading...
