7 - 24 WiNG 5.6 Access Point System Reference Guide
Attributes Lists whether the format specified applies only to the user name/password in mac-auth
or for all attributes that include a MAC address, such as calling-station-id or called-
station-id.
Server Pooling Mode Controls how requests are transmitted across RADIUS servers. Failover implies traversing
the list of servers if any server is unresponsive. Load Balanced uses all servers in a round-
robin fashion. The default setting is Failover.
Client Attempts Defines the number of times (1 - 10) an EAP request is transmitted to a wireless client
before giving up. The default setting is 3.
Request Timeout Defines the time after which an EAP Request to a wireless client is retried.
ID Request Timeout Defines the time (1 - 60 seconds) after which an EAP ID Request to a wireless client is
retried. The default setting is 30 seconds.
Retransmission Scale
Factor
Configures the scaling of the retransmission attempts. Timeout at each attempt is a
function of the request timeout factor and client attempts number. 100 (default setting)
implies a constant timeout at each retry; smaller values indicate more aggressive (shorter)
timeouts, larger numbers indicate more conservative (longer) timeouts on each successive
attempt.
Cisco VSA Audit Session
Id
Configures a vendor specific attribute (VSA) for CISCO to allow CISCO’s Identity Services
Engine (ISE) to validate the compliance of a client to the network’s policies such as the
validity of the virus definition files for the antivirus software or the definition files for a
anti-spy ware software.
Accounting Delay Time Select this option to enable the support of an accounting delay time attribute within
accounting requests. This setting is disabled by default.
Accounting Multi
Session ID
Select this option to enable the support of an accounting multi session ID attribute. This
setting is disabled by default.
Chargeable User ID Select this option to enable the support of chargeable user identity. This setting is
disabled by default.
Add Framed IP Address Select this option to add an IP address attribute to access requests. This setting is
disabled by default.
Framed MTU Set the framed MTU attribute (from 100 - 1500) used in access requests. The default
setting is 1400.
RFC5580 Location
Information
Select a support option for the RFC5580 location attribute. Options include None, include-
always and server-requested. The default setting is None.
RFC5580 Operator Name Provide a 63 character maximum RFC5580 operator name.
Service-Type Set the service type attribute value. Options include framed (default setting) and login.
NAS IPv6 Address Select this option to provide support for NAS IPv6 formatted addresses when not proxying.
This setting is disabled by default.
Proxy NAS Identifier Select a RADIUS attribute NAS identifier when proxying through the controller or RF
Domain manager. Options include originator (default setting) or proxier.
To Next Page
Loading...
