Quick Start 3 - 23
• Adopted to Controller - Select this option when deploying the access point as a controller managed (Dependent mode)
access point. Selecting this option closes the Initial AP Setup Wizard. An adopted access point obtains its configuration
from a profile stored on its managing controller. Any manual configuration changes are overwritten by the controller upon
reboot. For more information on configuring the access point in the Adopted to Controller mode, see
Adopt to a controller on page 3-35.
4. Select the Next button to start configuring the access point in the selected mode. If the Access Point Type is Virtual
Controller AP or Standard AP, see Network Topology Selection on page 3-24.
If the Access Point Type is Adopted to Controller, see Adopt to a controller on page 3-35.
To Next Page
Loading...
